Ricoh 9100DN - Aficio SP B/W Laser Printer Hardware Manual page 99

• Cancel duplex mode. Alternatively, select another tray using [Form Feed], or cancel the job.
Cannot select same Tray for: / Main sheet and Designate:
The main sheets and designation sheets are set to the same tray.
• Press the [Reset] key.
• Cancel the job and change the setting for the Main sheet tray and designation sheet tray, and then
try printing the job again.
Change Setting Tray #/Paper Size: Paper Type
The printer detected that the actual paper type was not the same as the paper tray size and paper type
setting.
• Load the indicated tray with the correct paper, or change the paper type/size using the dial or using
the [Paper Input] menu on the operation panel. Alternatively, select another tray using [Form Feed],
or cancel the job.
Close Finisher Front Cover
The finisher front cover is open.
• Close the finisher front cover.
Close Front Cover
The front cover is open.
• Close the front cover.
DHCP assigned Cannot change
An attempt to change the IP address, subnet mask or gateway address was made while [DHCP] was set
to [On].
• Make the change after setting [DHCP] to [Off].
• See p.39 "Ethernet Configuration".
Empty Punch Receptacle
Punch hole receptacle is full.
• Remove the punch-hole chips from the punch receptacle.
• Alternatively, disable the punch settings.
• See p.124 "Removing Punch Waste".
Error: Tray # Form Feed
There is a problem with the tray.
• Turn the power switch to Standby, and then to On. If the message appears again, call your sales /
service representative.
Error: Enter 10 or 26 characters
Error & Status Messages on the Display Panel
9
97