Setting A Wep Key - Ricoh 9100DN - Aficio SP B/W Laser Printer Hardware Manual

4. Configuration

Setting a WEP key

In the case of using a WEP key on a network, activate the WEP setting to be used for communication along
with WEP.
Consult your network administrator for the WEP key to use.
1. In the [IEEE 802.11b] menu, select [Security Method] using the [ ] or [ ] key, and then press
the [ Enter] key.
4
2. Press the [ ] or [ ] key to select [WEP], and then press the [
When activating the WEP Setting, you will need to enter the WEP key. If you have not entered the
key, be sure to enter it.
3. Press the [ ] or [ ] key to select [Change (HEX)] or [Change (ASCII)], and then press the
[ Enter] key.
4. Press the [ ] or [ ] key to enter the characters, and then press the [
• When entering the character, pressing [
• When using 64 bit WEP, up to 10 characters can be used for hexadecimal and up to five
characters for ASCII. When using 128 bit WEP, up to 26 characters can be used for hexadecimal
and up to 13 characters for ASCII.
• The number of characters that can be entered is limited to 10 or 26 for hexadecimal and 5 or
13 for ASCII.
• For ASCII character strings, uppercase and lowercase letters are recognized respectively.
5. Press the [Menu] key to return to the initial screen.
6. Print a configuration page to confirm the settings made.
50
Enter] key.
Enter] will mask it with an asterisk for security reasons.
Enter] key.