System Board Assembly; System Board Component Locations - IBM 8832L1X Maintenance And Troubleshooting Manual

Microprocessor
Figure 16. Removing the microprocessor
To install a microprocessor, see "Installing an additional processor" on page 25 and the
documentation provided with the microprocessor option for complete installation instructions.
Attention: If you are not installing a replacement microprocessor in socket 2, you must reinstall
the microprocessor heat sink filler in that socket.

System board assembly

This section shows the locations of items on the system board and describes how to replace the
system board assembly.

System board component locations

Figure 17 shows the location of the battery and of system board component connectors.
I/O expansion
option connector (J34)
I/O expansion
option connector (J131)
SCSI connector 2
(J94)
Figure 17. System board component locations
Microprocessor-
release lever
Battery Microprocessor socket 2
and heatsink (U70)
SCSI connector 1
Blade expansion
connector (J132)
DIMM 1 (J113)
DIMM 2 (J111)
DIMM 3 (J112)
DIMM 4 (J110)
Microprocessor 1
and heatsink (U66)
Control panel
connector (J64)
49