Table of Contents
Advertisement
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Open the cover (see "Opening the blade server cover" on page 20 for instructions).
5. If an SCSI drive is in SCSI connector 2, remove the drive and tray (see "Removing a SCSI hard
disk drive" on page 22 for instructions) (save the screws that secured the tray to the system
board); otherwise, remove the existing rear-board mounting screws (near SCSI connector 2).
6. Install the standard form-factor I/O expansion card:
Figure 11. Installing a standard form-factor expansion card in the blade server
Expansion card
Expansion
card tray
Hard disk
drive tray
a. Install the expansion card tray. Secure the tray to the system board with the screws from the
option kit, as shown Figure 11.
b. Orient the expansion card and slide the notch in the narrow end of the card into the raised
hook on the tray; then gently pivot the wide end of the card into the expansion card
connectors.
NOTE
For device driver and configuration information to complete the installation of the
expansion card, see the documentation for the option.
7. If you have other options to install or remove, do so now; otherwise, go to "Completing the
installation" on page 41.
31
Advertisement
Table of Contents
