Table of Contents
Advertisement
Alignment marks
Heat sink filler
Complete the following steps to install an additional processor:
1. Read the safety information beginning on page vii and "Installation guidelines" on page 17.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
SBCE unit (see "Removing the blade server from the SBCE unit" on page 19 for instructions).
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Open the blade server cover (see "Opening the blade server cover" on page 20 for instructions).
5. Remove the bezel assembly (see "Removing the blade server bezel assembly" on page 21 for
instructions).
6. Locate the processor socket on the system board.
7. Remove the heat-sink filler.
8. Install the processor:
a. Remove the protective cover, tape, or label from the surface of the processor socket, if one is
present.
b. Touch the non-conductive package containing the new processor to any unpainted metal
surface on the blade server or any unpainted metal surface on any other grounded rack
component in the rack you are installing the processor in for at least 2 seconds; then remove
the processor from the package.
Attention: Do not use any tools or sharp objects to lift the locking lever on the processor
socket. Doing so might result in permanent damage to the system board.
c. Rotate the locking lever on the processor socket from its closed and locked position until it
stops or clicks in the fully open position (approximately a 135° angle), as shown.
Attention: You must make sure that the locking lever on the processor socket is in the fully
open position before you insert the processor in the socket. Failure to do so might result in
permanent damage to the processor, processor socket, and system board.
26
Heat sink
Microprocessor
Microprocessor
locking lever
Intel® Server Compute Blade SBX82: Hardware Maintenance Manual and Troubleshooting Guide
Advertisement
Table of Contents
