Table of Contents
Advertisement
NOTE
See "System" on page 130 to determine which components should be replaced by a field
service technician.
Error code/symptom
189
(An attempt was made to access the
server with invalid passwords)
196
(Microprocessor cache mismatch)
198
(Microprocessor speed mismatch)
199
(Microprocessor technology mismatch)
201
(Memory test error.) If the server does
not have the latest level of BIOS
installed, update the BIOS to the latest
level and run the diagnostic program
again.
229
(Cache error)
262
(DRAM parity configuration error)
289
(DIMM disabled by POST or SMI)
289
(Unsupported memory configuration.
Booting min. valid config, Install in
pairs starting at DIMM 1. System
Halted)
289
(Unsupported memory configuration.
Install dual ranked DIMM pairs before
single ranked DIMM pairs. System
Halted)
289
(Unsupported memory configuration.
No Valid Dual Channel Config. Booting
Low Performance Single Channel
Mode)
104
•
Run the Configuration/Setup Utility program, and enter the
administrator password.
1. Ensure all microprocessors have the same cache size.
2.
Microprocessor with incorrect cache size.
1. Ensure all microprocessors are the same speed.
2.
Microprocessor with incorrect speed.
1. Ensure all microprocessors belong to the same CPU
family.
2.
Microprocessor with incorrect technology.
1. DIMM
2.
System board assembly
1. Microprocessor
2.
Optional microprocessor (if installed)
1. Run the Configuration/Setup Utility program.
2.
Battery.
3.
System board assembly.
1. Run the Configuration/Setup Utility program.
2.
Disabled DIMM.
3.
System board assembly
•
Verify that DIMMs are installed in pairs, starting with DIMM
1 and 2 (DIMM slots 1 and 2 must have DIMMs installed
before slots 3 and 4).
NOTE
For proper termination, both slots of a DIMM pair must
have DIMMs installed.
•
Exchange the DIMMs in slots 3 and 4 with the DIMMs in
slots 1 and 2.
NOTE
Dual-ranked DIMMs must be in slots 1 and 2.
1. Verify that:
•
DIMM slots 1 and 2 both have DIMMs installed.
•
No memory errors are indicated by the DIMM error LEDs.
or in the SBCE management module.
2.
DIMM indicated by the DIMM error LEDs or in the SBCE
management module.
Intel® Server Compute Blade SBX82: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
Advertisement
Table of Contents
