Table of Contents
Advertisement
•
Do not leave the device where others can handle and possibly damage it.
•
While the device is still in its non-conductive package, touch it to an unpainted metal part of the
SBCE unit or any unpainted metal surface on any other grounded rack component in the rack
you are installing the device in for at least 2 seconds. This drains static electricity from the
package and from your body.
•
Remove the device from its package and install it directly into the blade server without setting it
down. If it is necessary to set the device down, place it back into its non-conductive package. Do
not place the device on your blade server cover or on a metal surface.
•
Take additional care when handling devices during cold weather. Heating reduces indoor
humidity and increases static electricity.
Major components of the blade server
You must remove the blade server from the SBCE unit and remove the cover to see the components.
NOTE
The illustrations in this document might differ slightly from your hardware.
The following figure shows the major components of the SBX82 unit.
Figure 7. Major components of the Intel
Blade expansion
unit connector
SCSI hard
disk drives
Processor
heat sink filler
•
18
®
Server Compute Blade SBX82
DIMM
Heat sink
Processor
Intel® Server Compute Blade SBX82: Hardware Maintenance Manual and Troubleshooting Guide
Bezel
assembly
Advertisement
Table of Contents
