Table of Contents
Advertisement
a. Loosen one captive screw fully; then, loosen the other captive screw.
Attention: Loosening one screw fully before loosening the other screw will help to break
the thermal bond that adheres the heat sink to the microprocessor.
b. Gently pull the heat sink off of the microprocessor.
7. Rotate the locking lever on the microprocessor socket from its closed and locked position
(Figure 14) until it stops or clicks in the fully open position (approximately 135° angle), as
shown in Figure 15.
Figure 14. Microprocessor locking lever in the closed
position
Figure 15. Microprocessor locking lever in the fully
open position
Attention: You must ensure that the locking lever on the microprocessor socket is in the fully
open position before you remove the microprocessor from or insert the microprocessor into the
socket. Failure to do so might result in permanent damage to the microprocessor, microprocessor
socket, and system board.
8. Pull the microprocessor out of the socket.
48
Lever closed
Lever
fully
open
Intel® Server Compute Blade SBX82: Hardware Maintenance Manual and Troubleshooting Guide
Lever closed
Lever
fully
open
Advertisement
Table of Contents
