E120 and E320 11.3.x Hardware Guide
Installing SFPs
42
To install SFPs:
Ground yourself by using an antistatic wrist strap or other device and connect it to an
1.
ESD grounding jack.
Identify the following items on the SFP (Figure 22 on page 42):
2.
The connection circuitry on the base
The cable connectors on the front (which are protected by a dust cover)
Figure 22: Representative SFP
CAUTION: Be sure to position the SFP correctly before you install it.
Hold the SFP so that:
3.
The connection circuitry is adjacent to the LK and ACT markings on the IOA's
faceplate.
The cable connectors will be visible when you install the SFP.
For the correct orientation, see Figure 23 on page 43.
Copyright © 2010, Juniper Networks, Inc.