Configuring Handheld Communications; Configuring Ip Communication For The Zenworks Handheld Management Access; Point - Novell ZENWORKS HANDELD MANAGEMENT 7 SP1 IR4 - ADMINISTRATION Administration Manual

To enable or disable message transfers:
1 Run from the
console.exe
2 To enable transfers, click Operations, then click Enable Message Transfers.
or
To disable transfers, click Operations, then click Disable Message Transfers.
By default, message transfer is enabled and new messages are automatically placed in the proxy
service's message queue or out box.

7.2.5 Configuring Handheld Communications

You can configure the settings used by the IP client on the handheld to communicate with the
ZENworks Handheld Management Access Point.
1 Start
console.exe
2 Click Options > Configure > Handheld Communications.
3 In the Handheld Communication Settings dialog box, configure the following options:
If you want the handheld to use HHTP, select the Enable HTTP Encapsulation check box.
If you want the handheld to use SSL, select the Enable SSL check box.
If you want the handheld to communicate with SSL over HTTP, select both the Enable
HTTP Encapsulation and the Enable SSL check boxes.
If you want the handheld to connect to a port other than the default, deselect the Use
Default Port check box and specify the port the handheld should use to connect to the
ZENworks Handheld Management Access Point.
7.2.6 Configuring IP Communication for the ZENworks
Handheld Management Access Point
To configure the Access Point communication, click Options > Configure > Access Point
Communications. Alternatively, you can configure Access Point communication by launching
from the
cfgip.exe zfhap
and HTTP Communication between the ZENworks Handheld Management Server and the
ZENworks Handheld Management Access Point," on page
directory (by default,
zfhap
from the directory.
zfhap
directory. For more information, see
program files\novell\zfhap
Section B.1, "Configuring the SSL
158.
Making System Configuration Changes 137
).