Alcatel OmniSwitch 6624 Troubleshooting Manual page 601

show tech-support layer3 ospf
Creates a log file of the output of several Open Shortest Path First routing (OSPF) Command Line Inter-
face (CLI) commands.
show tech-support layer3 ospf
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
This command creates a file called tech_support_ospf.log in the /flash directory of the output
•
produced by the show ip ospf, show ip ospf area, show ip ospf interface, show ip ospf neighbor,
show ip ospf lsdb, show ip ospf host, show ip ospf border-routers, show ip ospf ext-lsdb, show ip
ospf redist, show ip ospf redist-filter, show ip ospf routes, show ip ospf virtual-link, and show ip
ospf debug CLI commands.
If an existing file called tech_support_ospf.log already exists then it will be overwritten when this
•
command is executed.
See the OmniSwitch CLI Reference Guide for more information on show commands.
•
See Appendix B, "Debug Commands,"
•
Examples
-> show tech-support layer3 ospf
.............
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support
show tech-support layer2
show tech-support layer3
OmniSwitch Troubleshooting Guide
for more information on debug commands.
Creates a log file of the output of system-wide CLI commands.
Creates a log file of the output of several Layer 2 CLI commands.
Creates a log file of the output of several Layer 3 CLI commands.
September 2005 page -7