Alcatel OmniSwitch 6624 Troubleshooting Manual page 200

OSPF Troubleshooting
If local, static, or any other external protocol routes need to be redistributed into OSPF then the first step is
to make that OSPF router to be a AS Border Router. This need OSPF status to be disabled.
-> ip ospf status disable
-> ip ospf asbr
-> ip ospf redist local
-> ip ospf redist-filter 0.0.0.0 0.0.0.0
->ip ospf redist status enable
-> ip ospf status enable
For any redistribution into OSPF, OSPF status needs to be disabled and then re-enabled. This allows all of
the routing tables on the NI to get synchronized.
Debug CLI has some OSPF commands just like RIP which shows the setup process. Debug Level by
default is set to 0. Debug type by default is set for errors.
-> show ip ospf debug
Debug Level
Types/Sections
error
warning
state
recv
send
flood
spf
lsdb
rdb
age
vlink
redist
summary
dbexch
hello
auth
area
intf
mip
info
setup
time
tm
error
warning
state
recv
page 12-24
= 0,
= on,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
= off,
Administratively enables/disables debugging error messages only. Error
messages provide information of program faults.
Administratively enables/disables debugging warning messages only.
Administratively enables/disables debugging OSPF state messages only.
State messages show the switch state in relation to its neighbors.
Administratively enables/disables debugging messages for packets
received by OSPF only.
OmniSwitch Troubleshooting Guide
Troubleshooting IP Routing
September 2005