Alcatel OmniSwitch 6624 Troubleshooting Manual page 404

debug ip packet
Displays IP debug configuration parameters. This command is generally used only when working with a
field engineer to debug a problem on the switch.
debug ip packet
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
This command is used to display IP debug configuration parameters. To start IP debugging you must enter
the start keyword.
Examples
-> debug ip packet
packet dump
timeout in seconds
output device
board
ether-type
protocol
direction
mcast/bcast
format
IP address filter
output definitions
packet dump
timeout in seconds
output device
ether-type
protocol
direction
mcast/bcast
format
ip address filter
page -18
IP debug administrative status (on/off).
Duration of the debug session, in seconds. (0 = off).
Output device for debug information (e.g., file, console).
Ethernet packet type to debug (e.g., ARP, IP).
Protocol type to debug (e.g., TCP, UDP).
Type of traffic to debug incoming (in) or outgoing (out).
Specifies whether or not to show broadcast/multicast packets.
Area of the packet to debug (e.g., header, text).
Interface to debug.
OmniSwitch Troubleshooting Guide
off,
0,
console,
all,
all,
all,
in + out,
on,
header,
September 2005