Alcatel OmniSwitch 6624 Troubleshooting Manual page 27

Troubleshooting the Switch System
The average on one minute is calculated from the average of 12 samples. Each sample is an average of the
CPU utilization during 5 seconds. Those values are stored in a table. The current minute (1 Min Avg or
"min") displays the average of the last 12 samples.
Every 60 seconds the average of the 12 samples is recorded into the average value for this minute. Those
values are stored in a form of 60 samples which represent one hour.
Most probably one of the above would help to localize the problem to a particular NI or to CMM. For
more details see, Section "Monitoring Switch Health" in the chapter titled "Diagnosing Switch Problems"
in the appropriate OmniSwitch Network Configuration Guide.
4 Check the switch log.
OmniSwitch 6624/6648 and 7700/7800/8800
Now, one of the most important things to check is the switch log. Switch log would contain the error
messages depending on the settings of the log levels and applications configured to generate error
messages. Default settings of the log switch log can be view using the command:
-> show swlog
Switch Logging is:
Log Device(s)
----------------
flash
console
Only Applications not at the level 'info' (6) are shown
Application ID
----------------------------
CHASSIS (64)
By default, log devices are set to be flash and console. This can be changed and specific log servers can be
used to log the messages, please refer to the Switch Management Guide for further details. The applica-
tion trace level is set for 'info'. Any error messages or informational messages would be logged in the
switch log.
Switch log should be viewed to see if any errors messages were generated by the switch. The command to
use is:
-> show log swlog
Displaying file contents for 'swlog2.log'
FILEID: fileName[swlog2.log], endPtr[32]
configSize[64000], currentSize[64000], mode[2]
Displaying file contents for 'swlog1.log'
FILEID: fileName[swlog1.log], endPtr[395]
configSize[64000], currentSize[64000], mode[1]
Time Stamp
------------------------+--------------+-------+--------------------------------
MON AUG 21 23:09:57 2023
ed on NI slot 1, GBIC port 2
MON AUG 21 23:28:33 2023
d on NI slot 1, GBIC port 1
MON AUG 21 23:28:33 2023
OmniSwitch Troubleshooting Guide
- INITIALIZED
- RUNNING
Level
debug3 (9)
Application
HSM-CHASSIS
HSM-CHASSIS
HSM-CHASSIS
September 2005
Troubleshooting System for OS-6624/6648 and OS-7/8XXX
Level Log Message
info == HSM == GBIC extraction detect
info == HSM == GBIC Insertion detecte
info == HSM == GBIC Insertion detecte
page 1-7