Alcatel OmniSwitch 6624 Troubleshooting Manual page 420

ip rip debug-type
Configures the type of RIP messages to debug. The debug feature on the switch is generally used only
under the direction of a field engineer. Use this command to configure the type of RIP debug warnings
(e.g., errors, warning) that will be logged.
ip rip debug-type [error] [warning] [recv] [send] [rdb] [age] [redist] [info] [setup] [time] [tm] [all]
no ip rip debug-type [error] [warning] [recv] [send] [rdb] [age] [redist] [info] [setup] [time] [tm] [all]
Syntax Definitions
error
warning
recv
send
rdb
age
redist
info
setup
time
all
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
Use the no form of the command to delete a debug type.
•
RIP must be enabled on the switch with the ip rip status CLI command before you can configure the
•
debug type.
To configure more than one debug type, you must repeat the command for each type.
•
Use the debug ip level
•
Examples
-> ip rip debug-type all
page -34
Includes error conditions, failures, processing errors, etc.
Includes general warnings, non-fatal conditions.
Enables debugging in the receive flow path of the code.
Enables debugging in the send flow path of the code.
Debugs RIP database handling.
Debugs code handling database entry aging/timeouts.
Debugs redistribution code.
Provides general information.
Provides information during initialization.
Debugs timeout handler.
Enables all debug options.
command to set the debug level for the configured type(s).
OmniSwitch Troubleshooting Guide September 2005