Alcatel OmniSwitch 6624 Troubleshooting Manual page 400

protocol
show-broadcast
show-multicast
Defaults
parameter
timeout
in | out | all
header | text | all
console | file
cmm | ni | all | none
arp | ip | hex | all
tcp | udp | icmp | igmp | num | all
on | off
on | off
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
If you use the basic command to start debug (debug ip packet start) the switch will use default param-
•
eters for all of the debug options. Once you configure one of the optional parameters, the switch will
use the new parameter(s) until changed.
If you do not specify a timeout value, the session will continue until it is stopped.
•
You must enter the start keyword to begin debugging.
•
The command debug ip packet
•
Examples
-> debug ip packet start timeout 1
Release History
Release 5.1; command was introduced.
page -14
Specifies a protocol type to debug. Specify tcp to debug TCP packets;
specify udp to debug UPD packets; specify icmp to debug ICMP pack-
ets; specify igmp to debug IGMP packets; specify num to numerically
specify a protocol (e.g., 89); specify all to debug all protocol types.
Specifies whether or not to display broadcast packets. Specify on to
display broadcast packets on the screen or in the log; specify off if you
do not want to display broadcast packets.
Specifies whether or not to display multicast packets. Specify on to
display multicast packets on the screen or in the log; specify off if you
do not want to display multicast packets.
default
-1
all
header
console
all
all
all
on
on
without the start keyword displays IP debug configuration parameters.
OmniSwitch Troubleshooting Guide September 2005