Alcatel OmniSwitch 6624 Troubleshooting Manual page 597

show tech-support layer2
Creates a log file of the output of several Layer 2 Command Line Interface (CLI) commands.
show tech-support layer2
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
This command creates a file called tech_support_layer2.log in the /flash directory of the output
•
produced by the show interfaces, show interfaces accounting, show interfaces collisions, show vlan
port, show vlan port mobile, show linkagg, show linkagg port, show spantree ports,
show mac-address-table count, show mac-address-table aging-time, show mac-address-table,
debug fabric stats, debug fabric fbus, debug fabric errors, debug fabric input, and debug fabric
stats CLI commands.
If an existing file called tech_support_layer2.log already exists then it will be overwritten when this
•
command is executed.
See the OmniSwitch CLI Reference Guide for more information on show commands.
•
See Appendix B, "Debug Commands,"
•
Examples
-> show tech-support layer2
................
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support
show tech-support layer3
OmniSwitch Troubleshooting Guide
for more information on the debug fabric commands.
Creates a log file of the output of system-wide CLI commands.
Creates a log file of the output of several Layer 3 CLI commands.
September 2005 page -3