The Authenticated Vlan Addebugshowcontext Function - Alcatel OmniSwitch 6624 Troubleshooting Manual

Troubleshooting Authenticated VLANs
- adDebugSetFilterLevel 0xX
- adDebugSetFilterPort X
- adDebugShowAvlanIp
- adDebugShowContext
- adDebugShowCounter
- adDebugShowPort
value = 1424 = 0x590
Working: [Kernel]->
Working: [Kernel]->
Working: [Kernel]->
Working: [Kernel]->
Working: [Kernel]->adDebugSetFilterLevel 0xff
value = 255 = 0xff
Working: [Kernel]->
Working: [Kernel]->adDebugSetFilterFrame 0xffff
value = 65535 = 0xffff
Working: [Kernel]->
AD INFO-> ARP request rcv.on glb.port=0x0,user port=1:Slot=1,Auth.IP
addr.=0x1,Src.MAC known=0x0,Cond.codes=0x16080,Frame=0x63dead8
AD INFO-> TELNET pkt.rcv.from qDispatcher: Slot=1,Glb.port=0x0,User
port=1,Msg.=0x6b01e98,Cond.codes=0x10080,Frame=0x63dead8
Notes.
1. The above is not a complete capture of the successful authentication process. A capture of the entire
process would be several pages.
2. It is recommended that you run this command only in a test environment and with a specific flat set,
rather than all "ffff" shown in the above example.

The Authenticated VLAN adDebugShowContext Function

The adDebugShowContext function displays the following output:
Working: [Kernel]->adDebugShowContext
AD show context
NI Slot
NI Slice
Configuration socket identifier
Packet socket identifier
Authenticated IP addr.configured
DNS name + 'avlBootpmode' config. = Yes
802.1x node parameters configured = Yes
Default Traffic before authent
Port bounding configured
avlBootpMode IP address
OmniSwitch Troubleshooting Guide
Bit 9: Configuration
: Set trace level filter
X = Bit field
Bit 1: ERROR
Bit 3: INFO
: Set user port number filter
Available only for INFO's trace
X = 0 = No filter
: Display Authentication IP addresses configured
: Display AD's context
: Display debug counters
: Display 802.1x port configured
September 2005
Bit 2: WARNING
= 1
= 0
= 286
= 287
= Yes
= No
= No
= 172.16.106.5
Dshell Troubleshooting
page 18-13