Alcatel OmniSwitch 6624 Troubleshooting Manual page 190

RIP Troubleshooting
11.40.150.1
The interface is enabled. Verify that local interface redistribution is enabled, using the commands:
->show ip rip redist
Status: ACT - Active
Protocol
-------------+-----------+----------+------
LOCAL
-> show ip rip redist-filter
Control: All-Sub - All Subnets
Aggreg
Permit: Perm
Status: ACT
Proto Destination
-------+---------------------+-------+------+------+-----+------
LOCAL 0.0.0.0/0
Verify that RIP is enabled globally and redistribution is also enabled, using the command:
-> show ip rip
Status
Host Route Support
Redistribution cfg status
Redistribution oper status = Enabled,
Route Tag
Hold Down Timer
Now, verify if the peer relationship is established between the two routers.
-> show ip rip peer
IP Address
----------------+------+-------+------+-------+-----------
9.9.1.2
11.40.150.2
11.40.150.100
11.40.211.1
11.41.211.1
This command shows the number of updates received as well as the time since the last update.
If the peer relationship is not formed then the next thing to look for will be the other router to check if it is
setup correctly.
Now, look at the routing table for RIP protocol, using the command:
-> show ip rip routes
Destination
------------------+------------------+------------------+-------
0.0.0.0
6.0.0.0
8.0.0.0
9.9.1.0
10.10.41.57
10.10.42.57
page 12-14
6 enabled
NIS - Not In Service
Metric Route-Tag
1 0
- Aggregate
- Permit
- Active
Control Permit Metric Tag
All-Sub
= Enabled,
= Enabled,
= Enabled,
= 0,
= 0
Total Bad Bad
Recvd Packets Routes Version
10 0 0
12 0 0
10 0 0
12 0 0
12 0 0
Mask
0.0.0.0
255.0.0.0
255.0.0.0
255.255.255.0
255.255.255.255
255.255.255.255
enabled 0/0(0)
Status
ACT
No-Sub - No Subnets
Deny - Deny
NIS - Not In Service
Perm 0 0
Secs since
last update
1 17
1 17
1 12
1 21
1 12
Gateway
11.41.211.1
9.9.1.2
11.40.150.100
9.9.1.1
11.40.211.1
11.41.211.1
OmniSwitch Troubleshooting Guide
Troubleshooting IP Routing
Status
ACT
Metric
2
2
2
1
2
2
September 2005