Alcatel OmniSwitch 6624 Troubleshooting Manual page 599

show tech-support layer3 rip
Creates a log file of the output of several Routing Information Protocol (RIP) Command Line Interface
(CLI) commands.
show tech-support layer3 rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
This command creates a file called tech_support_rip.log in the /flash directory of the output produced
•
by the show ip rip, show ip rip routes, show ip rip redist-filter, show ip rip redist, show ip rip
interface, show ip rip peer, and show ip rip debug CLI commands.
If an existing file called tech_support_rip.log already exists then it will be overwritten when this
•
command is executed.
See the OmniSwitch CLI Reference Guide for more information on show commands.
•
See Appendix B, "Debug Commands,"
•
Examples
-> show tech-support layer3 rip
.......
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support
show tech-support layer2
show tech-support layer3
OmniSwitch Troubleshooting Guide
for more information on debug commands.
Creates a log file of the output of system-wide CLI commands.
Creates a log file of the output of several Layer 2 CLI commands.
Creates a log file of the output of several Layer 3 CLI commands.
September 2005 page -5