Commands List - Ricoh Priport DX 4640PD Network Manual

Note
❒ If "Cannot write NVRAM information" appears, the changes are not
saved. Repeat the steps above, as necessary.
❒ The network interface module is automatically reset when the changes are
saved.
❒ When the network interface module is reset, active print jobs already sent
to the printer will be finished. However, jobs not already sent will be can-
celed.

Commands List

Use the "help" command to display remote maintenance use.
Note
❒ Enter "help" to display a list of commands that can be used.
msh> help
❒ Enter "help command_name" to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the "ifconfig" command to configure the Ethernet interface, IEEE 802.11b in-
terface, and the TCP/IP (IP address, subnet mask, broadcast address, default
gateway address) for the printer.
❖ Reference
msh> ifconfig
❖ Configuration
msh> ifconfig interface_name parameter address
Interface name
ether
*2
wlan
*1
If you did not enter an interface name, it will automatically be set to the Ethernet
interface.
*2
You can specify an interface when installing the IEEE 802.11b interface unit.
Parameter
(no parameter)
netmask
broadcast
Interface to be configured
*1
Ethernet interface
IEEE 802.11b interface
Meaning
IP address
subnet mask
broadcast address
Remote Maintenance by telnet
9
77