Ricoh Priport DX 4640PD Network Manual page 85

Access control
Use the "access" command to view and configure access control. You can also
specify two or more access ranges.
❖ Reference
msh> access
❖ Configuration
msh> access ✩ range start-address end-address
• ✩ represents a target number between 1 and 5. (Up to five access ranges
can be registered and selected.)
Example: To specify accessible IP addresses between 192.168.0.10 and
192.168.0.20:
msh> access 1 range 192.168.0.10 192.168.0.20
Note
❒ The access range restricts the workstations from which printing is possible
by means of an address. If you do not need to restrict printing, make the
setting "0.0.0.0".
❒ The entry is invalid if the start address is greater than the end address.
❒ Up to five access ranges can be specified. The entry is invalid if the target
number is omitted.
❒ Sessions other than those from a Web Image Monitor or telnet are limited
by access control.
❖ Access control initialization
msh> access flush
Note
❒ This restores the factory default so all access ranges become "0.0.0.0".
DHCP
Use the "dhcp" command to configure the DHCP settings.
❖ Reference
The following command displays the current DHCP settings.
msh> dhcp
❖ Configuration
You can configure the DHCP settings.
msh> dhcp interface_name [on | off]
Note
❒ Select [on] to enable DHCP. Select [off] to disable DHCP.
Remote Maintenance by telnet
9
79