Ricoh Priport DX 4640PD Network Manual page 95

Parameter
key {key value}
auth {open | shared}
rate {auto | 11m | 5.5m | 2m | 1m}
Note
❒ When changing the interface to IEEE 802.11b interface, see p.77 "TCP/IP ad-
dress".
❒ When configuring the IEEE 802.11b interface TCP/IP, see p.77 "TCP/IP ad-
dress".
spoolsw
Use the "spoolsw" command to configure Job Spool settings.
You can only specify diprint, lpr, ipp, ftp and smb protocol.
• The "spoolsw" command for configuring Job Spool settings is available only
when the optional hard disk is installed.
❖ View settings
The Job Spool setting appears.
msh> spoolsw
❖ Job Spool setting
msh> spoolsw spool {on | off}
Note
❒ Specify "on" to enable Job Spool, or "off" to disable it.
Remote Maintenance by telnet
Value to be configured
64-bit or 128-bit can be set.
Only 10 hexadecimal characters can be set
when using 64-bit; or 26 hexadecimal charac-
ters when using 128-bit.
Also, set 0x as the prefix.
To use this function, set the same WEP key
for all ports that transmit to each other.
You can set the authorized mode when using
WEP. The specified value and the authorized
mode are as follows:
open: Open system authorized (default)
shared: Shared key authorized
You can set the IEEE 802.11b transmission
speed.
The transmission speed you specify here is
the speed at which data is sent. You can re-
ceive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
9
89