Ricoh Priport DX 4640PD Network Manual page 94

Appendix
Setting IEEE 802.11b
Use the "wiconfig" command to configure IEEE 802.11b interface settings.
Limitation
❒ You can make settings when installing the IEEE 802.11b interface unit.
❖ View settings
The following command displays the current IEEE 802.11b interface settings.
msh> wiconfig
The following command displays the IEEE 802.11b card information.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is not working correctly, the IEEE 802.11b card
information is not displayed.
❖ Configuration
msh> wiconfig parameter
Parameter
mode [ap | 802.11adhoc | adhoc]
ssid ID value
9
channel frequency channel no.
enc {on | off}
88
Value to be configured
You can set infrastructure mode (ap), 802.11
ad hoc mode (802.11adhoc), or ad hoc mode
(adhoc).
The default is 802.11 ad hoc mode.
You can set SSID in infrastructure mode.
The characters that can be used are ASCII
0x20-0x7e (32 bytes).
SSID value is set automatically to the nearest
access point if the setting has not been made.
If the setting has not been made for ad hoc
mode, the same value as for infrastructure
mode or an "ASSID" value is automatically set.
You can set the channel.
You can specify from the following channels:
• Metric Version : 1-13
• Inch Version : 1-11
Set the same channel for all the machines you
are using.
You can enable or disable the WEP function.
To enable the WEP function, select [on]; to
disable it, select [off].
To start the WEP function, enter the correct
WEP key.