Ricoh Priport DX 4640PD Network Manual page 118

Appendix
Print queue <print queue name> cannot be
serviced by printer 0, <print server name>
Print server <print server name> has no printer.
Print sessions full
Printer <printer name> has no queue.
pserver start. (NetWare)
Required computer name (<Computer name>)
is duplicated name.
Required file server (<file server name>) not
found.
restarted.
sap enable, saptype=<SAP type>, sap-
name=<SAP name>
session<community name> not defined.
session_ipx<community name> not defined.
9
Set context to <NDS context name>
shutdown signal received. network service re-
booting...
smbd start. (NetBEUI)
Snmp over ip is ready.
Snmp over ipx is ready.
snmpd start.
started.
The print server received error <error
number> during attempt to log in to the net-
work.Access to the network was denied.Verify
that the print server name and password are
correct.
112
Message Causes and solutions
(In print server mode) The print queue name
cannot be serviced. Make sure that print
queue volume is on the specified file server.
(In print server mode) The printer is not as-
signed to the print server <print server
name>. Using NWadmin, assign the printer,
and then restart the printer device.
Cannot accept the print session.
(In print server mode) The print queue is not
assigned to the printer. Using NWadmin, as-
sign the print queue to the printer, and then
restart it.
(In print server mode) NetWare service has
started.
The same computer name is detected on the
network. The start job determines the compu-
ter name by adding it to the suffix (0,1....).
Configure a new computer name that is
unique.
Cannot find the required file server.
LPD has started.
The SAP function has started. The SAP (SAP
type and SAP name) packet is issued to adver-
tise the service on the NetWare server SAP ta-
ble.
The requested community name is not defined.
The requested community name is not defined.
A <NDS context name> has been set.
Rebooting the network service.
An smbd (SMB (Server Message Block) serv-
ice) has started.
Communication over TCP/IP via SNMP is
available.
Communication over IPX via SNMP is available.
SNMP service has started.
Direct print service has started.
Cannot log on to the file server. The print serv-
er is not registered or a password is specified.
Register the print server without specifying a
password.