Ricoh Priport DX 4640PD Network Manual page 88

Appendix
SNMP
Use the "snmp" command to display and edit SNMP configuration settings such
as the community name.
Note
❒ You can configure one of ten SNMP access settings numbered 1-10.
❒ If you change the community name, you must change your computer set-
tings. See p.98 "SNMP".
❒ Default access settings 1 and 2 are as follows:
Number
Community name
IP address
Access type
❖ Display
Shows SNMP information and available protocols.
msh> snmp ?
The following command displays the settings of registered number specified.
msh> snmp [registered_number]
Omitting the number displays all access settings.
msh> snmp [-p]
Note
❒ Add "-p" (as above) to have the information displayed one screen at a
time.
9
❖ Community name configuration
You can set the community name of the registered number.
msh> snmp number name community_name
Note
❒ The community name can consist of up to 15 characters.
❖ Access type configuration
You can select the access type from those listed below:
msh> snmp number type access_type
Access type
read
write
trap
no
82
1
public
0.0.0.0
read-only
trap off
Type of access permitted
Read only
Read and write
User notified of trap messages.
All access denied.
2
admin
0.0.0.0
read-write
trap off