Ricoh Priport DX 4640PD Network Manual page 89

❖ Protocol configuration
You should use the following command to set protocols to active or inactive.
If you set a protocol to inactive, all access settings for that protocol will be dis-
abled:
msh> snmp {ip | ipx} {on | off}
• "on" means active, "off" means inactive.
To change an access setting protocol, use the following command. However,
if you have disabled a protocol using the above command, making it active
here will have no effect.
msh> snmp number active {ip | ipx} {on | off}
❖ Access configuration
You can configure a host address according to protocols used.
The network interface module accepts requests only from hosts with "read-
only" or "read-write" access type addresses. Enter "0" to have the network in-
terface module accept requests from any host without requiring a specific
type of access.
msh> snmp number {ip | ipx} address
Note
❒ To specify TCP/IP protocol, enter "ip" followed by a space, and then the
IP address.
❒ To specify the IPX/SPX protocol, enter "ipx" followed by a space, and then
the IPX address followed by a decimal, and then the MAC address of the
network interface module.
The following is a sample configuration using the registration number 3 with
the IP address 192.168.15.16:
msh> snmp 3 ip 192.168.15.16
The following is a sample configuration using the registration number 3 with
the IPX address 7390A448, and the MAC address 00:00:74:62:5C:65:
msh> snmp 3 ipx 7390A448:0000
IPP
Use the "ipp" command to configure IPP settings.
❖ Viewing setting
The following command displays the current IPP setting:
msh> ipp
Example output:
timeout=900(sec)
auth=off
• The "timeout" setting specifies how many seconds the computer keeps try-
ing to access the network printer to send print jobs if no connection can be
made.
• The "auth" setting indicates the user authentication mode.
Remote Maintenance by telnet
9
83