Ricoh Priport DX 4640PD Network Manual page 100

Appendix
DNS
Use the "dns" command to configure or display DNS (Domain Name System)
settings.
❖ View setting
The following command displays current DNS settings:
msh> dns
❖ Using the DNS server obtained from the DHCP server
The following command enables/disables use the DNS server obtained from
the DHCP server:
msh> dns dhcp {valid | invalid}
• If you use the DNS server obtained from the DHCP server, select "valid".
If not, select "invalid".
If you set "valid", the DNS server from the DHCP server is prioritized.
❖ DNS server configuration
The following command enables/disables use of the DNS server address:
msh> dns number server server_address
The following is a sample configuration using an IP address of 192.168.15.16
on DNS 1 server:
msh> dns 1 server 192.168.15.16
• You can register up to three DNS server numbers.
• You cannot use "255.255.255.255" as the DNS server address.
Domain name
9
Use the "domainname" command to display or configure domain name set-
tings.
You can configure the Ethernet interface or IEEE 802.11b interface.
❖ View setting
The following command displays the current domain name:
msh> domainname
94