Ricoh Priport DX 4640PD Network Manual page 93

❖ Help URL Configuration
You can set URLs linked by clicking [Help] or [?] on Web Image Monitor.
msh> web help http://"Help URL or IP address"/help/
❖ Deleting Help URL
msh> web clear help
ROUTE
Use the "route" command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote computers using this com-
mand.
Note
❒ The maximum number of routing tables is 16.
Commands
route add {host | net} desti-
*1 *1
nation gateway
route delete {host | net}
*1
destination
*1
route get {destination
route active {host | net} des-
*1
tination on | off
route add default gateway
route flush
*1
IP address
SLP
Use the "slp" command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5/5.1, 6. Use the "slp" command to configure the value of TTL used by
the SLP multi-cast-packet.
Note
❒ The default value of TTL is "1". A search is executed only within a local seg-
ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Topics of setting
Adds a host/network route to "destination", and a gateway ad-
dress to "gateway" in the table. Host becomes the default.
Deletes a host/network route from the table. Host becomes the
default.
Displays only route information corresponding to a specified
}
destination. When the destination is unspecified, all routing in-
formation is displayed.
You can turn the specified destination on or off. Host becomes
the default.
*1 You can set the default gateway address.
Deletes all routing information.
Remote Maintenance by telnet
9
87