ZyXEL Communications VANTAGE CNM - V3.1 User Manual page 203

Figure 95 Device Operation > Device Configuration > Advanced > Static Route > Edit
The following table describes the labels in this screen.
Table 86 Device Operation > Device Configuration > Advanced > Static Route > Edit
LABEL
Route Name
Active
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Private
Apply
Cancel
Vantage CNM User's Guide
DESCRIPTION
Enter the name of the IP static route. Leave this field blank to delete this static
route.
This check box allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is an immediate neighbor of the
device that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as the device; over the WAN, the gateway
must be the IP address of one of the Remote Nodes.
Metric represents the cost of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
This parameter determines if the device will include this route to a remote node in
its RIP broadcasts.
Select this check box to keep this route private and not included in RIP broadcasts.
Clear this check box to propagate this route to other hosts through RIP broadcasts.
Click this to save your changes back to the device.
Click this to return to the previous screen.
Chapter 7 Device Advanced Settings
203