ZyXEL Communications VANTAGE CNM - V3.1 User Manual page 393

Figure 243 Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=dhcp
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
• If you have a static IP address, enter
IPADDR
followed by the subnet mask. The following example shows an example where the
static IP address is 192.168.1.10 and the subnet mask is 255.255.255.0.
Figure 244 Red Hat 9.0: Static IP Address Setting in ifconfig-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=192.168.1.10
NETMASK=255.255.255.0
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
2 If you know your DNS server IP address(es), enter the DNS server information in the
resolv.conf
where two DNS server IP addresses are specified.
Figure 245 Red Hat 9.0: DNS Settings in resolv.conf
nameserver 10.1.5.1
nameserver 10.1.5.2
3 After you edit and save the configuration files, you must restart the network card. Enter
./network restart
shows an example.
Figure 246 Red Hat 9.0: Restart Ethernet Card
[root@localhost init.d]# network restart
Shutting down interface eth0:
Shutting down loopback interface:
Setting network parameters:
Bringing up loopback interface:
Bringing up interface eth0:
Vantage CNM User's Guide
= followed by the IP address (in dotted decimal notation) and type
file in the directory. The following figure shows an example
/etc
in the
/etc/rc.d/init.d
Appendix B Setting up Your Computer's IP Address
in the
static BOOTPROTO=
directory. The following figure
[OK]
[OK]
[OK]
[OK]
[OK]
field. Type
=
NETMASK
393