ZyXEL Communications VANTAGE CNM - V3.1 User Manual page 280

Chapter 16 3G Monitor
The following table describes the labels in this screen.
Table 135 Monitor > 3G Monitor > Show Details (3G down, Budget Control enabled)
LABEL
Device Name
3G Connection
Status
IP/Netmask
IP Assignment
Service Provider
Roaming
Network
Last Connection
Up Time
3G Card
Manufacturer
3G Card Model
3G Card
Firmware
Revision
3G Card IMEI
280
DESCRIPTION
This is the name of the device where the 3G card is installed.
This displays Down when the 3G connection is down or not activated.
This displays Initializing when the selected device is configuring the 3G card with
AT commands.
This displays Ready to Connect when the 3G connection is idle before the
selected device triggers a call.
This displays Connecting when the 3G card is trying to connect to a network but
has not received a response from the base station.
This displays Connected when the 3G connection is up.
This displays Disconnecting when the selected device is dropping the 3G
connection. This field also displays whether the selected device is connected to a
UMTS/HSDPA network or GPRS/EDGE network.
This field also displays the type of the network to which the selected device is
connected. The network type varies depending on the 3G card you inserted and
could be UMTS, HSDPA, GPRS or EDGE when you insert a GSM 3G card, or
1xRTT, EVDO Rev.0 or EVDO Rev.A when you insert a CDMA 3G card.
Click Dial to dial up the 3G WAN connection.
This shows the port's IP address and subnet mask.
For the WAN, if the selected device gets its IP address automatically from an ISP,
this displays DHCP client when you're using Ethernet encapsulation and IPCP
Client when you're using PPPoE or PPTP encapsulation. Static displays if the
WAN port is using a manually entered static (fixed) IP address.
For the LAN, WLAN or DMZ, DHCP server displays when the selected device is
set to automatically give IP address information to the computers connected to the
LAN. DHCP relay displays when the selected device is set to forward IP address
assignment requests to another DHCP server. Static displays if the LAN port is
using a manually entered static (fixed) IP address. In this case, you must have
another DHCP server on your LAN, or else the computers must be manually
configured. For the dial backup port, this shows N/A when dial backup is disabled
and IPCP client when dial backup is enabled.
This displays the name of your network service provider or Limited Service when
the signal strength is too low or the ISP is limiting your access.
This field is available only when you insert a 3G card that supports the roaming
feature.
This displays whether the card is able to connect to other ISPs' base stations.
This displays how long the 3G connection has been up.
This displays the manufacturer of your 3G card.
This displays the model name of your 3G card.
This displays the version of the firmware currently used in the 3G card.
This field is available only when you insert a GSM (Global System for Mobile
Communications) or UMTS (Universal Mobile Telecommunications System) 3G
card.
This displays the International Mobile Equipment Identity (IMEI) which is the serial
number of the GSM or UMTS 3G wireless card. The IMEI is a unique 15-digit
number used to identify a mobile device.
Vantage CNM User's Guide