Output Settings; Tone Reverb Send - Roland Fantom XR Owner's Manual

Output Settings

For details on these settings, refer to "How to Make Rhythm
Set Settings" (p. 71).
Rhythm Output
Rhythm Out Assign
Specifies for each rhythm set how the direct sound will be output.
Value:
Output in stereo through multi-effects. You can also
MFX:
apply chorus or reverb to the sound that passes
through multi-effects.
A, B: Output to the OUTPUT A (MIX) jack or OUTPUT B
jack in stereo without passing through multi-effects.
1–4: Output to the INDIVIDUAL 1–4 jacks in mono
without passing through multi-effects.
If you've made settings so that sounds are separately routed to
the INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plug
is actually inserted in the INDIVIDUAL 2 jack, the sounds
routed to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixed
and output from the INDIVIDUAL 1 jack.
If the Mix/Parallel parameter is set to "MIX," all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 158).
Tone Out Assign
Specifies how the direct sound of each tone will be output.
Value:
MFX: Output in stereo through multi-effects. You can also
apply chorus or reverb to the sound that passes
through multi-effects.
A, B: Output to the OUTPUT A (MIX) jack or OUTPUT B
jack in stereo without passing through multi-effects.
Output to the INDIVIDUAL 1–4 jacks in mono
1–4:
without passing through multi-effects.
* If the Rhythm Output Assign is set to anything other than "TONE,"
these settings will be ignored.
* If you've made settings so that sounds are separately routed to the
INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plug is
actually inserted in the INDIVIDUAL 2 jack, the sounds routed to
INDIVIDUAL 1 and INDIVIDUAL 2 will be mixed and output from
the INDIVIDUAL 1 jack.
* If the Mix/Parallel parameter is set to "MIX," all sounds are output
from the OUTPUT A (MIX) jacks in stereo (p. 158).
* If you've set Tone Out Assign to "MFX," set the MFX Output
Assign parameter (p. 135) to specify the output destination of the
sound that has passed through the multi-effects.
* Chorus and reverb are output in mono at all times.
Creating a Rhythm Set
* The output destination of the signal after passing through the chorus
is set with the Chorus Output Select (p. 136) and the Chorus Output
Assign (p. 142).
* The output destination of the signal after passing through the reverb is
set with the Reverb Output Assign (p. 137).
Tone Out Level
Set the level of the signal that is sent to the output destination
specified by Patch/Tone Output Assign.
Value: 0–127
Tone Chorus Send (Send Level (Output=MFX))
Specifies the level of the signal sent to the chorus for each tone if the
tone is sent through MFX.
Value: 0–127
Tone Reverb Send (Send Level (Output=MFX))
Specifies the level of the signal sent to the reverb for each tone if the
tone is sent through MFX.
Value: 0–127
Tone Chorus Send
(Send Level (Output=non MFX))
Sets the level of the signal sent to chorus for each tone if the tone is
not sent through MFX.
Value: 0–127

Tone Reverb Send

(Send Level (Output=non MFX))
Sets the level of the signal sent to reverb for each tone if the tone is
not sent through MFX.
Value: 0–127
81