Multi Stage Phaser - Roland Fantom XR Owner's Manual

12: STEP PHASER
The phaser effect will be varied gradually.
fig.MFX-12
L in
Step Phaser
Step Phaser
R in
Parameter Value
Mode 4-STAGE, 8-STAGE, 12-
STAGE
Manual # 0–127
Rate # 0.05–10.00 Hz, note
Depth 0–127
Polarity INVERSE,
SYNCHRO
Resonance # 0–127
Cross -98– +98 %
Feedback
Step Rate # 0.10–20.00 Hz, note
Mix # 0–127
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
13: MLT STAGE PHASER

(MULTI STAGE PHASER)

Extremely high settings of the phase difference produce a deep
phaser effect.
fig.MFX-13
L in
Multi Stage
Phaser
R in
Resonance
Parameter Value
Mode 4-STAGE, 8-STAGE,
12-STAGE, 16-STAGE,
20-STAGE, 24-STAGE
Manual # 0–127
Rate # 0.05–10.00 Hz, note
Depth 0–127
Resonance # 0–127
Mix # 0–127
Pan # L64–63R
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
2-Band
L out
EQ
Mix
Mix
2-Band
R out
EQ
Description
Number of stages in the phaser
Adjusts the basic frequency
from which the sound will be
modulated.
Frequency of modulation
Depth of modulation
Selects whether the left and
right phase of the modulation
will be the same or the opposite.
INVERSE: The left and right
phase will be opposite. When
using a mono source, this
spreads the sound.
SYNCHRO: The left and
right phase will be the same.
Select this when inputting a
stereo source.
Amount of feedback
Adjusts the proportion of the
phaser sound that is fed back
into the effect. Negative (-) set-
tings will invert the phase.
Rate of the step-wise change in
the phaser effect
Level of the phase-shifted sound
Gain of the low range
Gain of the high range
Output Level
L out
Pan L
2-Band
EQ
Mix
Pan R
R out
Description
Number of phaser stages
Adjusts the basic frequency
from which the sound will be
modulated.
Frequency of modulation
Depth of modulation
Amount of feedback
Level of the phase-shifted
sound
Stereo location of the output
sound
Gain of the low range
Gain of the high range
Output Level
14: INFINITE PHASER
A phaser that continues raising/lowering the frequency at which the
sound is modulated.
fig.MFX-14
L in
Infinite Phaser
R in
Parameter Range
Mode 1, 2, 3, 4
Speed # -100– +100
Resonance # 0–127
Mix # 0–127
Pan # L64–63R
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
15: RING MODULATOR
This is an effect that applies amplitude modulation (AM) to the input
signal, producing bell-like sounds. You can also change the
modulation frequency in response to changes in the volume of the
sound sent into the effect.
fig.MFX-15
L in
Ring Mod 2-Band EQ
R in
Ring Mod
2-Band EQ
Parameter Value
Frequency # 0–127
Sens # 0–127
Polarity UP, DOWN
Low Gain -15– +15 dB
High Gain -15– +15 dB
Balance # D100:0W–
D0:100W
Level 0–127
Effects List
Pan L
2-Band EQ
Pan R
Explanation
Higher values will produce a
deeper phaser effect.
Speed at which to raise or lower
the frequency at which the
sound is modulated
(+: upward / -: downward)
Amount of feedback
Volume of the phase-shifted
sound
Panning of the output sound
Amount of boost/cut for the
low-frequency range
Amount of boost/cut for the
high-frequency range
Output volume
L out
R out
Description
Adjusts the frequency at which modula-
tion is applied.
Adjusts the amount of frequency modula-
tion applied.
Determines whether the frequency modu-
lation moves towards higher frequencies
(UP) or lower frequencies (DOWN).
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct sound
(D) and the effect sound (W)
Output level
L out
R out
197