Choosing A Patch; Basic Procedure For Choosing A Patch; Choosing A Group - Roland Fantom XR Owner's Manual

Playing Sounds

Choosing a Patch

Basic Procedure for Choosing a Patch

fig.03-006
1.
Press [MODE] so the button lights in red.
You will enter Patch mode, and the Patch Play screen will appear.
2.
Press or
fig.03-006a.e
Patch number
3.
Turn the VALUE dial or use [INC][DEC] to select the patch.

Choosing a Group

1.
Press [MODE] so the button lights in red.
You will enter Patch mode, and the Patch Play screen will appear.
2.
Press [GROUP] to select the patch group.
The group changes as shown below.
USER (User) -> PR-A (Preset A) -> . . . -> PR-H (Preset H) -> GM (General MIDI) ->
Card (Memory Card) -> XP-A (Expansion A) -> . . . -> XP-F (Expansion F)
fig.03-007.e
Patch group
Alternatively, press [CURSOR] to move the cursor to the patch group, and turn the VALUE dial
or use [INC][DEC] to select the patch group.
24
to move the cursor to the patch number.
3 3 1
2
The value will change more
rapidly if you turn the dial
while holding down [VALUE].
XP-A through XP-F appear
only if the corresponding
expansion board is installed.
"Bank Select and Program
Change Correspondence
Chart" (p. 270)