Chorus Type - Roland Fantom XR Owner's Manual

Adding Effects
Chorus
fig.22-022

Chorus Type

11
Selects either chorus or delay.
Value
0 (Off): Neither chorus or delay is used.
1 (Chorus):Chorus is used.
2 (Delay): Delay is used.
3 (GM2 Chorus):General MIDI 2 chorus
Chorus Output
fig.22-022a
Chorus Output Level
12
Adjusts the volume of the sound that has passed through
chorus.
Value: 0–127
Chorus Output Select
13
Specifies how the sound routed through chorus will be output.
Value
MAIN: Output to the OUTPUT jacks in stereo.
REV: Output to reverb in mono.
M+R: Output to the OUTPUT jacks in stereo, and to reverb
in mono.
When set to "MAIN" or "M+R," the OUTPUT jack from which
the sound is output is set in Chorus Output Assign (
136
Chorus Output Assign
14
Selects the pair of OUTPUT jacks to which the chorus sound is
routed when Chorus Output Select (
"M+R."
Value
A: Output to the OUTPUT A (MIX) jacks in stereo.
B: Output to the OUTPUT B jacks in stereo.
When Chorus Output Select (
will have no effect.
If the Mix/Parallel parameter is set to "MIX," all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 158).
Reverb
fig.22-023
Reverb Type
15
Selects the type of reverb.
Value
0 (Off):
1 (Reverb):
2 (SRV Room):
3 (SRV Hall):
4 (SRV Plate):
14
).
5 (GM2 Reverb): General MIDI 2 reverb
13
) is set to "MAIN" or
13
) is set to "REV," this setting
Reverb is not used.
Normal reverb
This reverb simulates typical room acoustic
reflections.
This reverb simulates typical concert hall
acoustic reflections.
This reverb simulates a reverb plate, a
popular type of artificial reverb unit that
derives its sound from the vibration of a
metallic plate. You can also achieve unusual
metallic-sounding reverbs using "SRV
Plate."