When Scanning Is Not Performed As Expected - Ricoh IS200E Operating Instructions Manual

Appendix

When Scanning is Not Performed as Expected

The scanned image is dirty.
Image is distorted or out of position.
The scanned image is upside down.
No image results from scanning.
The printer that you have specified for print-
ing scanned data does not print after you per-
form a Print Scan operation.
11
182
Condition Possible Cause and Required Action
• Exposure glass, the ADF exposure glass,
white sheet or original roller is dirty.
• Clean the exposure glass, the ADF expo-
sure glass, white sheet, or original roller ⇒
p.193 "Cleaning"
• The original was moved while scanning.
Do not move the original while scanning.
• The original was not pressed flat against
the exposure glass. Make sure that the orig-
inal is pressed flat against the exposure
glass.
• The original was placed upside down.
Place the original in the correct orientation.
⇒ p.119 "Original Orientation"
• The original was placed with the front and
back reversed. When the original is placed
directly on the exposure glass, the side to
be scanned must face down. When the
original is fed via the ADF, the side to be
scanned must face up.
• If an error message is shown on the display
of this machine, see p.183 "When an Error
Message Appears" to eliminate the error.
• If no error message is displayed on this ma-
chine, it means an error has occurred on the
printer, or the printer may not be config-
ured properly. Confirm that the printer op-
erates normally, and is properly
configured. See the manual that comes
with the printer.