Ricoh IS200E Operating Instructions Manual page 75

• Show Options after Each Scan Job
The screen for selecting the next operation appears on the display panel of
this machine.
When scanning is performed from the ADF
The following screen appears when all the originals in the ADF are
scanned.
• Press [Add] to continue scanning to add scanned data to the current im-
age file.
• Pressing [New Job] finishes the current scanning job and sends the
scanned data. You can start a new job with the current settings after the
scanned data is sent.
• Pressing [OK] finishes the current scanning job, sends the scanned data,
and then returns to the initial screen when the power is turned on.
When scanning is performed from the exposure glass
The following screen appears when you press [Finish] after scanning the
original on the exposure glass.
• Pressing [New Job] finishes the current scanning job and sends the
scanned data. You can start a new job with the current settings after the
scanned data is sent.
• Pressing [OK] finishes the current scanning job, sends the scanned data,
and then returns to the initial screen when the power is turned on.
Note
❒ You can specify the time during which the screen for selecting the next
operation remains displayed using [Configuration] → [Basic Settings] →
[Scanner] → [Wait Time for Additional Scanning] on the Web Status Monitor.
See the Web Status Monitor Help.
❒ When you perform an [Enter Custom Send File] operation from the Web
Status Monitor, selecting [New Job] and [OK] on the selection screen both
finishes the current scanning job, sends the scanned data, and the [Enter
Custom Send File] settings are retained. Press [PrevMenu] to return to the
initial screen when the power is turned on.
SendScan Settings
67
3