Table of Contents
Advertisement
Appendix
When the Originals are Not Fed Correctly
A A A A
Remove the originals from the ADF.
B B B B
Lift the Pressure Panel or open the ADF cover.
Unusual conditions of the Original Table will be corrected.
C C C C
Shutdown the Pressure Panel or the ADF cover.
6
Note
❒ When you shut the ADF cover, please confirm the two magnets are fixed
on the magnet catch and the cover is closed tightly.
When Scanning is Not Performed as Expected
The scanned image is dirty.
The originals are damaged when fed to the
ADF.
Image is distorted or out of position.
66
ADC048S
Condition
Possible Cause and Required Action
• The Exposure Glass, the ADF Exposure
Glass, Background panel, Feed roller or
Original Roller is dirty.
• Clean the Exposure Glass, the ADF Expo-
sure Glass, Background panel, Feed roller
or Original Roller. ⇒ p.71 "Cleaning"
• Set the paper thickness changeover lever
correctly or it may damage originals.
Please confirm the lever and the paper
thickness of the originals. When you scan
the originals thicker than 128g/m
(242.5bls), turn the changeover lever on
your side (thick paper mode).
• The original was moved while scanning.
Do not move the original while scanning.
• The original was not pressed flat against
the exposure glass. Make sure that the orig-
inal is pressed flat against the exposure
glass.
2
Advertisement
Table of Contents
