Understanding The Operator Panel; Message Display - Kyocera Mita FS-1900N Operation Manual

Understanding the Operator Panel

Understanding the Operator Panel

Message Display

The operator panel has a LCD message display, three indicators, and eight
keys.
Messages that appear on the display and functions of indicators and keys
are explained in the sections that follows.
The message display gives information in the form of short messages. The
eight messages listed below are displayed during normal warm-up and
printing.
Other messages that may appear when the printer needs the operator's
attention are explained in
Message
Self test
Please wait
Ready
Processing
Sleeping
Cancelling data
Waiting
FormFeed Time Out
Chapter 4.
The printer is self-testing after power-up.
The printer is warming up and is not ready. When
the printer is switched on for the first time after the
toner container is installed,
also appears.
The printer is ready to print.
The printer is receiving data, generating graphics,
reading a CompactFlash card/Microdrive, or
printing.
The printer is in sleep mode. The printer wakes
from sleep mode whenever the
operator panel is pressed, the cover is opened or
closed, or data is received. The printer then warms
up and goes online. The time that the printer takes
to enter sleep mode depends on the sleep timer
setting.
Jobs inside the printer are being canceled. To cancel
a job, see the table on page 1-5.
The printer is waiting for the end-of-job command
before printing the last page. Pressing the
allows you to obtain the last page immediately.
The printer is printing the last page after a waiting
period.
1-2
Meaning
(Adding toner)
GO key on the
GO
key