Mp Tray Mode - Kyocera Mita FS-1900N Operation Manual

MP Tray Mode

The MP tray can be used in either of two modes – first or cassette. The
MP tray feed paper differently depending on the mode:
• Cassette Mode
This is the default mode. The MP tray acts in the same manner as
other paper source. The printer can correctly feed paper from any paper
source as you command on the printer driver. The cassette mode
provides a faster printing speed than the first mode.
• First Mode
The MP tray automatically feeds paper placed on the MP tray
overriding another paper source that is selected on the printer driver.
After all paper sheets in the MP tray have been used up (approximately
100 sheets [A4 size, 0.11 mm thickness]), paper will be fed from the
paper source originally selected. This mode is convenient to feed paper
of special size or type without reloading the current paper source.
However, the MP tray must be kept empty if you desire to feed paper
from the intended paper source.
This menu does not appears when the option envelope feeder is installed on
the printer.
The maximum capacity for the MP tray of 100 sheets is based on A4
paper. If you use Legal size paper on the MP tray, the number of paper
you use should be considerably smaller than 100 sheets to avoid
Note
possible paper jam.
To switch the MP tray to First mode, proceed as follows:
1
Press the MENU key.
2
Press the
Paper Handling >
3
Press the > key.
4
Press the
>MP Tray Mode
Cassette
or key repeatedly until Paper Handling > appears.
or key repeatedly until >MP Tray Mode appears.
1-37
Paper Handling