Adhesive-Backed Labels - Kyocera Mita FS-1900N Operation Manual

Special Paper

Adhesive-Backed Labels

The basic rule for printing on adhesive labels is that the adhesive must
never come into contact with any part of the printer. Adhesive paper
sticking to the drum or rollers will damage the printer.
Be sure to feed label paper from the MP tray. Feeding label paper from a
paper cassette may cause printer failure.
Note
Label paper has a structure comprised of three layers, as shown in the
figure below. The top sheet is printed on. The adhesive layer consists of
pressure-sensitive adhesives. The carrier sheet (also called the linear or
backing sheet) holds the labels until use. Due to the complexity of its
composition, adhesive-backed label paper is particularly likely to give
trouble in printing.
Adhesive label paper must be entirely covered by its top sheet, with no
spaces between the individual labels. Labels with spaces in between are
apt to peel off, causing serious paper jam problems.
Some label paper is manufactured with an extra margin of top sheet
around the edge. Do not remove the extra top sheet from the carrier sheet
until after printing is finished.
Acceptable
Top sheet
Carrier sheet
2-8
Top sheet (white bond paper)
Adhesive
Carrier sheet
Unacceptable