Kyocera Mita FS-1900N Operation Manual page 78

e-MPS
8
Press the or
9
Press the ENTER key. If you entered an access code for the printer
driver, the ID input line appears. Enter the four-digit access code
entered in the printer driver and press the ENTER key. To enter the
ID, press the < or > key to move the cursor to the number to be
changed and then enter the correct number by pressing the
key.
>Agenda
ID
10
You can specify the number of copies to print. To increase the copy
count, press the
>Agenda
Copies
11
Press the ENTER key to finalize the copy count. The printer prints
the specified number of copies for the job.
Deleting a Stored Job
To delete a stored job, proceed as follows:
1
Follow steps 1 through 8 in the above section.
2
When the title of the job to be printed is displayed (Agenda, in this
example), press the ENTER key. If you entered an access code for the
printer driver, enter the four-digit access code and press the ENTER
key.
>Agenda
Copies
3
Press the key repeatedly until Delete appears for the number of
copies.
>Agenda
Delete
4
Press the ENTER key. The stored job is deleted from the Microdrive.
key to display the desired job title.
0000
key; to decrease the
001
001
_
1-64
key.
or