Assigning Expansion Instruction Function Codes - Omron CPM2C Operation Manual

Programming Console Operations
4-2-7

Assigning Expansion Instruction Function Codes

1,2,3...
164
CLR SHIFT
2. Press the SHIFT and then the 1 Key to turn off the buzzer.
SHIFT
3. Press the SHIFT and then the 1 Key again to turn the buzzer back ON.
SHIFT
This operation is used to display or change the expansion instructions
assigned to expansion instruction function codes. The assignments can be
displayed in any mode, but can be changed in PROGRAM mode only.
Operation
Read assignment OK
Change assignment No
Assign expansion instruction function codes before inputting the program. The
CPM2C will not operate properly if expansion instructions aren't assigned cor-
rectly. An expansion instruction can be assigned to one function code only.
The PC Setup must be set for user-defined expansion instruction assign-
ments. Set bits 8 to 11 of DM 6602 to 1 and turn the PC's power off and then
on again to enable the new setting.
There is a table on page 290 showing the default function code assignments
in the CPM2C.
1. Press the CLR Key to bring up the initial display.
2. Press the EXT Key to display the assignment for the first function code
(17).
3. Press the Up and Down Arrow Keys to scroll through the expansion in-
struction function codes.
4. Press the CHG Key to assign a different expansion instruction to the se-
lected function code.
5. Press the Up and Down Arrow Keys to scroll through the expansion in-
structions that can be assigned to the selected function code.
6. Press the WRITE Key to assign the displayed instruction to the function
code.
<MONITOR>
CLR
<MONITOR>
B
1
The buzzer will not sound
when "BZ" is not displayed.
<MONITOR>
B
1
RUN MONITOR
OK
No
INST TBL READ
FUN017:ASFT
EXT
INST TBL READ
FUN018:FUN
E
INST TBL
FUN018:FUN ~????
CHG
INST TBL
FUN018:FUN ~HEX
E
Section 4-2
BZ
BZ
PROGRAM
OK
OK
CHG?
CHG?