Entering The Password - Omron CPM2C Operation Manual

Using a Programming Console
4-1-5

Entering the Password

To gain access to the PC's programming functions, you must first enter the
password. The password prevents unauthorized access to the program.
The PC prompts you for a password when PC power is turned on or, if PC
power is already on, after the Programming Console has been connected to
the PC. To gain access to the system when the "Password!" message
appears, press CLR and then MONTR. Then press CLR to clear the display.
If the Programming Console is connected to the PC when PC power is
already on, the first display below will indicate the mode the PC was in before
the Programming Console was connected. Ensure that the PC is in PRO-
GRAM mode before you enter the password. When the password is
entered, the PC will shift to the mode set on the mode switch, causing PC
operation to begin if the mode is set to RUN or MONITOR. The mode can be
changed to RUN or MONITOR with the mode switch after entering the pass-
word.
CLR
MONTR
Indicates the mode set by the mode selector switch.
Section 4-1
159