Omron CPM2C Operation Manual page 325

Revision code
05 April 2002
06 November 2004
07 September 2005
08 February 2008
302
Revision Histoy
Date
Specifications were changed to update to CPM2C-CIF01-V1 Peripheral/RS-232C Adapter Unit. Spe-
cific changes are as follows:
Page 4: Last line on page removed.
Pages 6, 12, 13, 32, 76, 139, 142 to 144, 160, 161, 218, 222, 224, 280, and 283: Graphics and model
numbers (-V1 added) changed.
Pages 52, 54 to 56, 60, 61, 63 to 67, and 108 to 110: "COM ( )" changed to "COM (-) or "-" added to
diagram.
Page 72: Table added.
Pages 73, 183, 161, and 237: Notes added.
Page 75: Information added on SW1.
Page 229: Digital Controller Board added.
Page 231: Read data area and write data area corrected at bottom of page.
Page 244: Description of bits 12 to 15 at bottom of page altered.
Page 255: "Read" added in table at bottom of page.
Page 266: DM 0013 corrected (including setting of bits 9 to 11).
Page 275: Cable added.
Minor changes and corrections to information were made, and Appendix D was created from informa-
tion in Section 4. Specific changes are as follows:
Page xiii: Safety precaution added.
Pages xvi and xvii: Standard changed from EN50081-2 to EN61000-6-4.
Page 2: Information on sharing Programming Devices changed.
Pages 12, 75, 275, and 280: Diagram showing Peripheral/RS-232C Adapter Unit changed.
Page 23: Optional battery backup lifetime changed from 2 to 5 years.
Page 30: Lot number 31800 changed to 3180O in note.
Pages 40 and 43: Numbers added to outputs in diagram.
Pages 54, 55, 56, 64, 65, 107, 131, and 132: Note added.
Page 95: Diagram showing connectors changed.
Page 114: Diagram added.
Page 133: Applicable cable model changed for G70D-SOC16-1 and G70D-FOM16-1 Relay Terminals.
Pages 139 to 140: Information removed and new information on CX-Programmer connections added.
Page 144: Note changed.
Pages 147 to 159: Information on SYSMAC-CPT and SYSMAC Support Software removed from Sec-
tion 4 and most of this information moved to Appendix D (new).
Page 168: Functions added to table.
Page 170: Information on new operations added.
Page 193: "C" changed to "CNT" and "T" changed to "TIM" in Data column of table.
Page 215: Information on battery replacement changed.
Page 219: "-15PC" suffix added to ATMEL model number for EEPROM.
Page 228: Table added.
Page 231: "Starting address of separate area" added to end of control data area table.
Pages 251 and 253: Meaning of FF16 error code changed and corresponding note added.
Page 274: SYSMAC-CPT and SYSMAC Support Software removed from table.
Page 278: Diagrams changed.
Page 292: Appendix D added.
Page v: Information on general precautions notation added.
Page xi: Information on liability and warranty added.
Page 4: Change number of mountable Analog I/O Units to 3 and added note.
Pages 5, 116, and 117: Added note.
Page 91: Added recommended Screwdriver to top table.
Page 137: Added sentence to bottom of page.
Page 138: Remove last heading and paragraph from page.
Revised content