Memory All Clear; Um Allocation Information Read - Omron CPM2C Operation Manual

Programming Console Operations
4-2-3

Memory All Clear

4-2-4

UM Allocation Information Read

162
4. Press 123 to specify 123 as the starting program address.
B C
1 2
5. Press the MONTR Key to clear the specified regions of memory.
MONTR
With the upgrade from CX-Programmer version 1.2 to version 2.0, I/O com-
ments can be used with the CPM2A. Use the Memory All Clear operation to
delete data from the I/O comment area. All I/O memory area data will be
cleared by this operation and the area size will be set to the default value of
2.0 Kwords.
RUN
No No
RESET
CLR SET NOT
MONTR
The Memory All Clear operation must be performed to clear the program
including the I/O comment area. The normal operation to clear memory will
not clear the I/O comment area.
The UM allocation information can be read when an I/O comment area has
been set from the CX-Programmer (Ver. 2.0 or higher) to display the I/O com-
ment area and ladder program area sizes. Refer to the CX-Programmer Ver-
sion 2.0 (or higher) Operation Manual (W437) for information on changing the
size of the I/O comment area.
RUN
OK OK
CLR FUN
I/O comment area: 2 Kwords
(2,048 is truncated for display.)
00000MEMORY CLR?
HR
CNT
00123MEMORY CLR?
D HR
3
00000MEMORY CLR
END HR
MONITOR PROGRAM
OK
00000MEM ALLCLR?
EXT
00000MEM ALLCLR?
END
MONITOR PROGRAM
OK
VER
CA LAD
02 04.1
Ladder program area: 4.1 Kwords
(4,096 is truncated for display.)
Section 4-2
DM
DM
DM