Table of Contents
Advertisement
Material Usage
When key 4 is pressed to display the amount of mate-
rial used, the key 4 light turns green and the schematic
light blinks for the proportioning pump that corresponds
to the keypad display. See Fig. 29 and 30.
The display will show the amount of material A, materi-
al B, or total material (A + B) used since the value was
last reset.
Press the keypad arrow keys (
the proportioner pump A, pump B, and total (A + B)
material usage displays; the schematic light that is
blinking will also switch between pump A and B in
correspondence to the displayed value. For total
material usage, both schematic lights will blink.
NOTE:
The keypad displays of material A and B usage are
based on the cycle counts per gallon/liter that were
entered during setup for pump A and B.
There is no alarm associated with this function.
Material Usage Reset
To reset the material usage totalizers to zero, press
key 4 for five seconds.
Manual or Spray Mode
) to toggle through
Fig. 29
A
B
A B
Fig. 30
4
A/B
S
A
A/B
S
B
B AB
A
A
B
Material B Usage
Advertisement
Table of Contents
