IBM 3745 Problem Determination Manual page 46

o
o
o
o
o
ALARM 8C: TOKEN-R.NG FRAME TIME-OUT hhmmss ref code
Cause:
Action:
Token-ring adapter interface
Control program
Incorrect software generation
• Check and, if neces&ary, correct generation parameters. There may be a mismatch
between hardware configuration and software generation parameters.
• Reactivate the link from the host and retry.
• If the problem recurs:
CO
and give reference code.
ALARM 80: TRSS HARDWARE INITIALIZATION ERROR ON TRA xx
hhmmss ref code
Cause:
Local token-ring adapter (TRA)
Action:
• Re-activate the link from the host and retry.
• If the problem recurs:
CO
and give reference code.
ALARM 8E: TIC x (TRA yy) EXTERNAL ERROR zz. REFER TO PO GUIDE hhmmss
Cause:
Action:
External error to the 3745.
Refer to the following table which describes the actions to perform according to the external
error codes (zz).
Table
1-1 (Page 1 of 5). Token-Rin.g External Error Codes
External
Error Error Description Probable Cause User Action
Codes
First verify that there is not a TIC
type 1 in the 3745 with a TIC Type
2
Physical link activation failure
definition statement for it in the
02
The parameters that NTRI passed to
User or NTRI
NCP SYSGEN. If this is not the
the TIC at TIC initialization time are
case, then it is likely that a NTRI
invalid.
internal problem exists, so contact
an IBM" software service
repr-esentative.
Determine the MAC addresses of
Physical link activation failure
the devices in the token ring
The TIC detected another device on
network, and ensure that no two
07
the ring it is attached to with the
User devices with the same address are
same token ring MAC address as
on the same ring. Two devices may
the TIC.
have the same MAC address as
long as they are on separate rings.
Chapter 1. Alarms and Alerts
1-29