IBM 3745 Problem Determination Manual page 256

o
o
o
c
o
Problems on All Lines (LIC1 to LIC4)
6
Wait approximately 30 seconds. One of following messages is displayed on line
. II'
• WRAP TEST COMPLETED: THE LlC IS FAULTY
Action:
E1
- Go to step?
• WRAP TEST COMPLETED: THE LlC "S OK
Action:
- Check if the line weights on the scanner exceeds 100.
- If the sum is greater than
100~
you must disable some of the fines.
- If the problem persists,
CO
(hardware service).
• WRAP TEST CANCELED, UNABLE TO SET LINE TO WRAP MODE
Action:
CO
(hardware service).
Note: Other wrap test messages are documented in the 3745 'advanced Operations Guide.
7 .
Doone of the following:
• If there is a spare LlC, go to step 8 .
.• . 1f there is no spare LlC-, but there are spare port(s) defined for failing lines:
- Perform a port swap as described in the 3745 Advanced Operations Guide.
• If the problem persists:
CO
Chapter 9. L1C and Line Problems (LSS)
,9-5